Just a short note on progress with the Jasper Circle Jig.
All is going according to plan.
I have successfully cut one baffle, it took a while but I think steady progress (not rushed ) is the key to success here.
Actually, the spacing and setting the actual baffle cut out diameters was a real challenge.
Many thanks to Bo for his assistance.
There was also quite a bit of preparation including a special framing jig which had to be arranged to hold the 2 18 mm MDF panels in precise alignment while cutting.
Because of the flange diameters were much larger in diameter for the 2307 and the 2405, the inner and outer layers had to be cut seperately while maintaining the same centre Pin hole for the Jasper circle jig.
I will post some work in progress pics in a few days. Its really starting to look like a 4345 now (no cardboard baffles here Bo)
Ian