I am finally getting around to choosing some mounts/brackets for my 2397's and wonder what you guys use. I run 2 pairs of L220/L222's and they stand side by side. They (as you might know), have a spacer sticking out of the top sub-enclosure where the passive crossover used to be. I will cut about 3" off these now that I've triamped them but will still have a great little ledge to use as the rear mounting spot for the 2397's bracket set up. I would like to have the freedom to adjust the front up and down tilt, so that is important, the side to side would be nice but not as important. Could you post a picture of what you have?. I plan on mounting 2441's on them in the near future but use 2421 1" drivers for now. Thanks for any help, Steve G
Reply With Quote