Doing a free air VLF sweep on my ME150 woofers produced a clicking sound at and below 7hz. I think Pos had a similar experience. The woofers perform superbly when used as intended.
Doing a free air VLF sweep on my ME150 woofers produced a clicking sound at and below 7hz. I think Pos had a similar experience. The woofers perform superbly when used as intended.
It's been told before not to push those woofers, really avoid anything below 20-25Hz. It can be the VC wire or the woofer is bottoming out.
One of my 2225h just had issues with clicking noise. I removed the cone and there seems to be some kind of washer loose on the airgap. I think its part of the motor, but has come loose during time. Not sure if its possible to fix or not. If anyone has info of the 2225 structure im all ears.
That's most likely the mass ring Which has probably parted company with the cone
. You now have a 2234 😁
Mass-ring cant fit trough the airgap and 2225 dont even have the ring.
My bad. Misread 2225 on my phone.
No worries! I have spare woofers, but still intrested of figuring this out.
I had a 2225 re-coned as a 2235 over time something came loose in the motor structure. Don't know if it's part of a toasted VC or what else it could be. Can't imagine the flux stabilization ring coming loose but who knows. Sucks have a fresh re-cone on a "bad" frame!
Rob
"I could be arguing in my spare time"
I'll guess that the 2225's flux-stabilizing ring has come loose inside the "well" ( down below the ) voice-coil gap ( circling the pole-piece ).
The thread ( behind the following pic ) shows the best save ( to-date ) of a magnetic structure ( that I'm aware of ).
If I'm right ( & the ring is a sngle piece ) you might be able to maneuver it back into it's slot beside the pole-piece and then apply some glue/goop ( all through the tiny VC gap ) to keep it in place ( home repairs are always worth a shot IMO ).
Thank you Earl K
I was looking for an explanation and now i got it. Ring is one piece for sure, you got that right. On your picture the ring is sitting on the bottom so i guess thats the place where it should be glued.
I wouldnt be suprised if theres something wrong with the cone or vc. Have to take a closer look.
There are currently 1 users browsing this thread. (0 members and 1 guests)