I am getting ready to build the cabs for my speakers and was looking over the plans submitted by Mr. Reissen. At the bottom of the thread he adds that all joints are factory locking miter but I don't see that in the plans the joints are rabbited. I don't have access to a 10in. table saw and if I am off just a small amount those miter joints are not going to fit whereas the other joints will be more forgiving Since I am going to cover with veneer anyway what the heck. Any input on these joints?

These are my tools........Skill77 with a very good blade, good straight edge, clamps, good router, good skills, glue and screws.