In order to settle a bet and to save a LOT of PM chatter, I dug out all the
array type horns here and took group picture(s)
These flat front horns preceded the PT series horns and were used in the Array,
Sound Power I and P series and a host of Dance / Club and custom shop speakers.
When these were first used, the only drivers in the 1.5" format were the 2447 ( ferrite )
and 2450SL / 2451 ( Nd ). Now if you look at the pictures a few things are noticeable:
(A) The 2450SL's mounting hole pattern was smaller SO horns common to some series /
versions were drilled for BOTH patterns. The newer gen drivers will fit.
(B) The Depth of the horn changes with pattern and like almost ALL horns, deeper is narrower.
(C) The 2333 60 degree horn was ONLY used in the wedge monitors ( with or without a separate
rotating flange assembly ) and it is NOT AS WIDE...and the mounting holes ARE ON TOP/BOTTOM...
note: JBL has 2 different part numbers for this depending on cabinet version..??
(Ca) Rudy has discovered another variant with a full mounting flange...see pics below. This
might explain the additional part number!
(D) The Variants used in the Sound Power I and P series ( export only?? ) had driver mounting
flanges that UNSCREWED so the driver could be removed from the tight space inside the box.
( note that the 90 degree variant isn't pictured - only the 60 )
(E) The Horns are made of aluminum WITH the exception of some versions of the 2332.
The version in the later array cabs is shiny Fiberglas where the version in the DMS-1 monitor
is spray-coated on the face like the rest of the baffle.
(F) No reference in any lit found gives a model number for the 45 degree horn so *I* am calling
it the 2334. ha - prove me wrong...
sub