2450SL-8 with 2332 Horn

[ivica]

I have an opportunity last weekend to measure some 2450SL-8 drivers with 2332 Horns. Most of the data that I have get were expectable, except the horizontal dispersion. There are some differences ( about 2dB) in the response around 10kHz between the drivers too.

[ivica]

I have an opportunity last weekend to measure some 2450SL-8 drivers with 2332 Horns. Most of the data that I have get were expectable, except the horizontal dispersion. There are some differences ( about 2dB) in the response around 10kHz between the drivers too.

Network Starting point. http://www.audioheritage.org/vbullet...l=1#post346302

[sebackman]

Ivica,

Did you acctually test your filter suggestion or only computer model it?

Best regards
//RoB

[ivica]

Ivica, Did you acctually test your filter suggestion or only computer model it? Best regards //RoB

Hi sebackman,

That is only computer model incorporating measured driver response
I would suggest you to measure both drivers, as I have not so good "pairing" of mine 2450SL
as you can seen on attached figure. On about 10kHz the difference is about 2.5dB, and the slope at HF region is different too,
so I have to make different networks in order to EQ them to become compatible up to 12~14kHz
Possible solutions is attached

Regards Ivica

[sebackman]

Hi

Thank you for the info.

Mine (2450SL/2332) are both very close to original JBL curve. Would it be possible to tweak network to the DMS-1 curve and maybe simplify ? (see link below.)

http://www.audioheritage.org/vbullet...ll=1#post11626

I will use 2206 below and 2405 above.

Thank you
//RoB

[Champster]

Hi

Thank you for the info.

Mine (2450SL/2332) are both very close to original JBL curve. Would it be possible to tweak network to the DMS-1 curve and maybe simplify ? (see link below.)

http://www.audioheritage.org/vbullet...ll=1#post11626

I will use 2206 below and 2405 above.

Thank you
//RoB

Rob,
Did you ever make progress on your project?
Paul

[sebackman]

Hi Paul,

Yes I did, but I went with digital active XO's. I have toyed arround with digital filters a few years and it is much easier to tune them, than analog filters. -At least for me :-). I used old JBL SR4722X cabinets which I rebuilt to accept 2450SL/2332 horn. No 077 is needed in my application with the digital XO's.

I use dual 2226 subs below the 2206's.

Sound very nice.

Best regards
RoB

[ivica]

Hi Paul,

Yes I did, but I went with digital active XO's...... No 077 is needed in my application with the digital XO's.


RoB

Any measurements to be shown ?

regards
ivica