I have asked this question on another forum but I wanted to get a more definitive answer. I am new to Altec speakers so please bear with me. I am putting together a version of a 9844 and have a 406a driver and 811 horn as well as the 800hz XO. the 12 inch drivers from this system were 414-16Cs. I do not have these, but rather, have a pair of 414A 16 ohms. Will these match together okay? I am concerned about a possible difference in magnet material or speaker parameters. Attached are two pictures of the drivers:
414-16C
414A
They look different but the info I received so far is they are both Alnico. Correct? If not, is there a negative consequence of using the 414As with the 9844 XO which used the 414-16Cs?
Thanks for setting me straight!
Dave