I've actually been running my 4343s quad-amped via DSP for the last few months. I'll see if I can write up a thread/guide on my approach to it over the weekend. Quite the learning curve, but very...
Type: Posts; User: Galucha; Keyword(s):
I've actually been running my 4343s quad-amped via DSP for the last few months. I'll see if I can write up a thread/guide on my approach to it over the weekend. Quite the learning curve, but very...
Hi, I just finished a 4343 build this spring. There are several other builds documented on this forum. This post helped me tremendously in getting the correct dimensions on the baffle.
...
Thanks for the info! I haven't really gotten into active crossovers much yet, although I've considered the 5234 & 5235 before. I plan on using DSP with this build, since I already have a pretty good...
Thanks for the input! I didn't plan on going too low with the horns, but I suppose that's a nice advantage of the 2360s. Seems like another reason to go with a 2445 driver. I do have a couple of 2123...
Curious if anyone has ran any of the older 1 inch compression drivers with newer horns. I'm planning on buying a set of 2360A horns that came up on marketplace near me. From what I've gathered...
Thanks!
Aaaand I'm done (for now at least)!
I used 3M super 77 spray adhesive to glue on the foilcals. I still need to paint the inside edges of the cabinets, but unfortunately I'm all out of paint and...
Applied the oil, and started final assembly.9038490385
Moving on to veneering. So far so good. 9038290383
Correction - a LOT of block sanding. While I'm doing 1 cabinet, I went ahead and glued the lower baffle onto the second cabinet so it would have time to set.
90379
Working on the edge bevels & mitres today. Everything is affixed securely to the front of the cabinets, just have to do some block sanding to get the joints all trued up.9037490375
I feel like at...
Sounds like a lot of work!
Painted the baffles today. Spent a long time prepping these. After stripping the existing paint, I used wood filler to fill in the existing screw holes before drilling new ones with a 3/8"...
Bit of an update on progress. I've cut the bevels for the front edges at a 30° angle out of walnut. Very happy with the result. I'll be glueing, clamping, and using a pin nailer to affix them to the...
Weather is warming up enough to start working in my shop, so finally making some headway on this project. I've been listening to these for the last few weeks and experimenting with room placement. So...
That is extremely helpful. Thank you!
Good morning!
I recently acquired a pair of partially completed custom 4343 clones. I believe they may have previously belonged to a member of this forum actually. After having a chance to look...