Originally Posted by
quindecima
Today my router bits came so I routed out the holes for the tubes and rabbeted the sides for the 2123 enclosures and glued the crap out of them. I couldn't find a bit that was the same thickness as the cardboard tube wall so I blue taped up the bearing until it was close and it worked fine. The 2123 enclosures turned out to be somewhat of a bitch, if you don't have as table saw be real careful and check everything BEFORE you glue them up. I have a good saw, blades and straightedges and NOTHING takes the place of a 10in or even better a 12in table saw. Make sure you locate the holes for the drivers before you cut them out it will benefit you greatly. I frustrated the crap out of my self on the 2123 enclosures but my wife made me two tacos and opened a nice bottle of the grape, I have almost recovered. The only hard part left is to route out the baffle on the back side for the enclosures. I am going to build a jig for that.