2451SL-16 - Round thread on connector?

Printable View

12-09-2022, 04:52 PM
emilime75

2451SL-16 - Round thread on connector?

For the life of me I can't upload a photo to this site. Posting a link to a photo of my actual driver in my Google photo album if anyone would like to see what I'm talking about. Instead of the typical push terminals, this has a round connector with a threaded body. There is a large nut holding the connector to an aluminum plate that covers the area where the push terminals would normally be. From the looks of it, I would assume whatever cable connector is used with this would push in and then thread on to lock. Wild guess, but maybe it also has a rubber seal for moisture protection? This was purchased as a NOS part, and didn't come out of any cabinet.https://photos.app.goo.gl/JeX2fdjatRe1azUV6
12-09-2022, 05:26 PM
grumpy

Looking to change to push connectors? or use as-is and get the connector info?... either way, it looks rather OEM (Special run for outside use?) and JBLPro may be of assistance. :dont-know:
12-10-2022, 01:23 PM
toddalin

Like I said elsewhere, it looks like a two prong CB mic connector and you need the female.https://vetco.net/products/2-pin-fem...IaAuqYEALw_wcB
12-10-2022, 02:06 PM
Riley Casey

Possibly a Switchcraft EN3 connector or variation on it .https://www.mouser.com/new/switchcraft/switchcraften3/
12-10-2022, 02:46 PM
rusty jefferson

Quote:

Originally Posted by emilime75

For the life of me I can't upload a photo to this site...

Post 26 of this thread, follow the instructions. You may have to resize the image down if it still doesn't work but this should fix it.
https://www.audioheritage.org/vbulle...ad-error/page2
12-10-2022, 07:49 PM
toddalin

Quote:

Originally Posted by rusty jefferson

Post 26 of this thread, follow the instructions. You may have to resize the image down if it still doesn't work but this should fix it.https://www.audioheritage.org/vbulle...ad-error/page2

OK, post this address in your browser and it should take you to the place that sells them, complete with picture.https://vetco.net/products/2-pin-fem...IaAuqYEALw_wcB
12-12-2022, 08:46 PM
emilime75

Quote:

Originally Posted by grumpy

Looking to change to push connectors? or use as-is and get the connector info?... either way, it looks rather OEM (Special run for outside use?) and JBLPro may be of assistance. :dont-know:

I'd prefer to find the cable end and use it as is. Tried taking the round connector off and it felt like I was about to damage something, so I stopped.
12-12-2022, 08:47 PM
emilime75

Quote:

Originally Posted by toddalin

OK, post this address in your browser and it should take you to the place that sells them, complete with picture.https://vetco.net/products/2-pin-fem...IaAuqYEALw_wcB

This does look like it may be it, thanks.