Hi all.
I have plans to build 4312A clones.
I have a comlete setup of 035ti tweeters, 104h-2 midranges and 2213H woofers.
I need to know dimensions of the enclosures and the port tubes.
All info would be most appreciated.
Best regards John.
Printable View
Hi all.
I have plans to build 4312A clones.
I have a comlete setup of 035ti tweeters, 104h-2 midranges and 2213H woofers.
I need to know dimensions of the enclosures and the port tubes.
All info would be most appreciated.
Best regards John.
Hi John,
Happy new year 🎈🎆🧨🎉
I just made a drawing with Excel, all dimensions are in millimeters.
Here is the front side :
Attachment 90108
The back side :
Attachment 90109
And the top view of AB cut :
Attachment 90110
I cant measure the thickness of the walls ...
The inside diameter of the port is about 70.8 mm but it is impossible to measure it because it is an angled port 😥 .
I hope it will help you,
Best regards from France,
Pascal
This will help me alot.
Are the measurements from your 4312 Mk 2? I used to have a pair of the Mk 2īs that is why i am doing this project.
I have another question. I would be happy if you could provide the measures 1- 10 on my picture.
Attachment 90111
Best regards John J.
Hi John,
Here are my measurements in millimeters:
1 = 133 for the midrange speaker that is roughly a square
2 = 72 the diameter of the hole is 75
3 = 127
4 = 77 from the inner side of the right wall to the center of the left potentiometer knob
5 = 32 from the inner side of the right wall to the center of the right potentiometer knob
6 =29 from the inner side of the upper wall to the center of the potentiometer knobs
7 = 30 for the midrange speaker that is roughly a square
8 = 122
9 = 20 for the tweeter
10 = 20
Don't forget that the front walls are mirrored !
For the tube port, according to the JBL Component Exploded View, the part number is 52211 and it seems to be symetrical so I will try to make a drawing with the supposed dimensions.
Rgds,
Pascal
Here is the port drawing with estimated dimensions.
Attachment 90119
Pascal
Thanks alot Pascal.
This will defenetly help me build speakers close to original.
Now i can start to draw the buildplans.
This project will take time but i will post pictures of my progress here.
Thanks again for the help.
Best regards John.
Are you going to use a crossover similar to the original or something like the 4412?
I have not thought about that. Was planning to do according to original spec.
How will the 2213H woofer work with the 4412 filters? Mids and Highs are the same in both models.
Project has been on hold because i got hold on a pair of 4312MkII's i have been enjoying.
I am now starting to look at this project again because i have the drivers needed.
/John.