Alan Fletcher
08-10-2005, 02:55 PM
A while ago I posted about a rattling LE14A. Well, now that I have the speakers at home and have had the ability to put them through their paces, I have found the problem. Aparently the reconer did not use enough black adhesive at the coil to contact points. There is a visible gap between the Aquaplas on the cone and the glue joint where the voice coil leads penetrate the cone, causing a rattle when the cone vibrates at certain frequencies.
Rather than make a messy repair with some other type of adhesive, I was wondering if someone could supply me with the correct adhesive. Pelly3s?
Also, what is the consistency of this stuff when uncured? Could I put it in a syringe and inject it underneath the gap?
Thanks,
-Alan
Rather than make a messy repair with some other type of adhesive, I was wondering if someone could supply me with the correct adhesive. Pelly3s?
Also, what is the consistency of this stuff when uncured? Could I put it in a syringe and inject it underneath the gap?
Thanks,
-Alan