jlovda
08-06-2005, 03:59 PM
I was under the impression the M12 kit used an LE5-2 alnico magnet driver. I recently found an L-88P Owner's Manual. It describes the driver this way:
Nominal diameter: 5 Inches
Voice coil: 7/8 Inch, edge wound copper ribbon
Magnet assembly: 2.75 pounds
Flux density: 16,500 gauss
EIA sensitivity: 46 dB
From information I found on this forum, the LE5-2 does NOT use edgewound ribbon wire. The picture in the manual is very poor with no detail.
Is this a special version of the LE5-2?:blink:
Thanks,
John Lovda
Nominal diameter: 5 Inches
Voice coil: 7/8 Inch, edge wound copper ribbon
Magnet assembly: 2.75 pounds
Flux density: 16,500 gauss
EIA sensitivity: 46 dB
From information I found on this forum, the LE5-2 does NOT use edgewound ribbon wire. The picture in the manual is very poor with no detail.
Is this a special version of the LE5-2?:blink:
Thanks,
John Lovda