View Full Version : Which one?
Little ID help?
Board is marked with a "45" circled- no p/n that I can see- is it on one of the components? Posts are twist-type. L-pads are the usual.
Thanks...
4313B
05-04-2005, 04:23 PM
Give me the inductor values. My first guess would be an N96/N112/N150A variant.
*****
6 uF?
13.5 uF?
4 uF?
Yeah, from inspection it should be one of the above.
2.5 mH iron core
0.75 mH air core
0.30 mH air core
3.5 mH 7.5 ohm air core
far end is .3mh
middle (small one) is 3.5mh
one turned on it's side is ? marking is in the glue. It has the most windings of the three.
That's what I thought too- 150's or 96's... but was not sure since they look just a bit dif from the ones in my L96 and L150A.
Damn, you're good! Fastest Network ID in the whole midwest!
4313B
05-04-2005, 04:28 PM
Yep, N96/N112/N150A variant. You should be able to find the tech sheets elsewhere on the forum if you need them.
***
...but?
***
Yeah, they varied. Some came with a big 2.5 mH air core and some came with PC boards. My guess is that's from an early L112.
Good to have ANOTHER spare then...:blink:
If anyone REALLY needs them for a 4313B mod, let me know. 3 pairs are enough for me... the fourth can go to a new home. If not, I'll add to the collection.
Thanks Giskard... I knew you would know just by looking for a few seconds.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.