sebackman
11-13-2015, 11:13 AM
Hi,
I have a pair of LE1400H that need new edges.
LE1400H was made for the never commissioned Ti7000 and as far as I can understand it is basically a "version" of the LE14H-3 using the LE14H-3 basket but with a 2227 magnet and probably a LE14H-3 cone (or near) but with a foam surround as opposed to the rubber on the LE14H-3/4.
When re-foaming do you think it would make sense to use the rubber surround from the newer LE14H-3/4 as opposed to foam surround when changing them, or is it better to go with the originals?
And if so, are the LE14H-3/4 rubber surround available at all?
The units are fine, one is new and one is used but seem good. Even if one is new I will change the edge on both of the to be sure that they behave the same.68183
They are not going into a factory JBL system but being paired with an M2 waveguide and a BSS DSP, so filter/cabinet is not an issue.
Kind regards
//RoB
I have a pair of LE1400H that need new edges.
LE1400H was made for the never commissioned Ti7000 and as far as I can understand it is basically a "version" of the LE14H-3 using the LE14H-3 basket but with a 2227 magnet and probably a LE14H-3 cone (or near) but with a foam surround as opposed to the rubber on the LE14H-3/4.
When re-foaming do you think it would make sense to use the rubber surround from the newer LE14H-3/4 as opposed to foam surround when changing them, or is it better to go with the originals?
And if so, are the LE14H-3/4 rubber surround available at all?
The units are fine, one is new and one is used but seem good. Even if one is new I will change the edge on both of the to be sure that they behave the same.68183
They are not going into a factory JBL system but being paired with an M2 waveguide and a BSS DSP, so filter/cabinet is not an issue.
Kind regards
//RoB