View Full Version : Impedance Disobedience
Robert3564
08-21-2013, 06:47 AM
Hi:
I was thinking if using a 3106 crossover to an 8 ohm 2404H "baby butt" ultra HF. Will I have a problem with the 8 ohm impedance; it seems that the x-over is specified for 16 ohms. Should I consider modifications to x-over?
Thanks for tolerance with newbie questions!!
spkrman57
08-21-2013, 06:52 AM
Hi:
I was thinking if using a 3106 crossover to an 8 ohm 2404H "baby butt" ultra HF. Will I have a problem with the 8 ohm impedance; it seems that the x-over is specified for 16 ohms. Should I consider modifications to x-over?
Thanks for tolerance with newbie questions!!
It might be closer to 10 ohms(driver AC impedance - not the DCR which will be closer to 75% of the drivers normal impedance).
Let us know what you measure.
Regards, Ron
Robert3564
08-21-2013, 07:01 AM
DCR is 7.0 and 6.6
spkrman57
08-21-2013, 08:46 AM
DCR is 7.0 and 6.6
With lower impedance you will raise the crossover frequency up some.
What speaker system that you are using all this with?
Ron sends...
Robert3564
08-25-2013, 11:22 AM
With lower impedance you will raise the crossover frequency up some.
What speaker system that you are using all this with?
Ron sends...
le-85 with a 2231h for LF
spkrman57
08-25-2013, 11:34 AM
See how it sounds.
Maybe it will mesh better than you think it can.
Regards, Ron
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.