Optimizing A4 vott. help neded thanks.

[gyuri]

hello everyone,. I am a newbie to this site. I hope you can help me on my next project. restoring/ customizing A4 vott. here is what I have one pair of 211 enclosures ( landed these on a flea market and that's where the idea started) 515bs for low frequency drivers 1505b horns 288-16h or 16c for high frequency drivers no crossovers yet I do have a single 1803b horn and I did consider trying to locate another one. not sure on this idea. my theater/media room is 21' *23' with 9' ceiling I have successfully restored and A5 with the same drivers and 1505b horns a few years ago. it was a very nice systems with the hiraga crossover design but I did not have room for them at the time so I had to sell them. any suggestions, guidance would be greatly appreciated. thank you. gy.

[Altec Best]

Nice set up !!! Since there is a lack of replies here.Try the Altec user board. :) Best of luck with that setup ! 515B's,1505's and 288H's :applaud:

http://www.hostboard.com/forums/f700/altec-users-board.html

[Lee in Montreal]

I am curious. Why a 515 and not a 416-C? I am not an Altec expert at all, but the 416-C seems to be a good driver for that purpose.

[maxserg]

If I'm not mistaken A4 setup were used un theatres or cinemas. 515B were used in theese cabinets.