username
11-02-2011, 12:16 AM
finaly found plans on the 211 explaining the curv of the horn maybe i overlooked it maybe its new to the internet idk i couldnt find it on this site so whatever here it is
braces r 2x3 and 2x4 i think il be able to find out the dimension of the support behind the horn with trigonometry (i think) because the 2 look flush in the front
idk y part of the cone is hidden im sure there is a reason tho im relying on the plans for the 210 to piece more of this pic togeather the 210 plan says the speaker hole is 9 13/16 this pic shows its 8 1/2 so il probly just make this part just like the 210 only with the hole a little smaller also il just position the fiber glass in the center leaving 2 inches above and below it
these cabinets r made very reasonably specific to keep tones flat r these small changes bad? any suggestions on building these?
braces r 2x3 and 2x4 i think il be able to find out the dimension of the support behind the horn with trigonometry (i think) because the 2 look flush in the front
idk y part of the cone is hidden im sure there is a reason tho im relying on the plans for the 210 to piece more of this pic togeather the 210 plan says the speaker hole is 9 13/16 this pic shows its 8 1/2 so il probly just make this part just like the 210 only with the hole a little smaller also il just position the fiber glass in the center leaving 2 inches above and below it
these cabinets r made very reasonably specific to keep tones flat r these small changes bad? any suggestions on building these?