lgvenable
12-12-2009, 10:05 PM
I want to build some custom front drivers into killer cabinents; driven my mon-triamplifiers (made by ab systems at 250 >150>150 wpc 8ohm).
The 713's have active crossovers: http://www.abamps.com/713a.pdf;
these were a rare find at the Chicago Museum of Science and Industry; and I'd like to configure my older L00T system using the w new DIY speakers:
with
2202H mid bass (as mid bass horns?)
2445J compression drivers wit 2385A horns (as mid horns)
and 2404H Baby Cheeks as my HF drivers.
I need suggestions to build a mid bass driver box (horn loaded?), then set the amps for the proper x-over points to get an even flat response.
Alternately: I'm willing to get dBX drivereack 260 to help time align the output on each channel will have its own set of amplifiers for every two speakers
All of these were part of the museums electronics before they went IMAX.
The 713's have active crossovers: http://www.abamps.com/713a.pdf;
these were a rare find at the Chicago Museum of Science and Industry; and I'd like to configure my older L00T system using the w new DIY speakers:
with
2202H mid bass (as mid bass horns?)
2445J compression drivers wit 2385A horns (as mid horns)
and 2404H Baby Cheeks as my HF drivers.
I need suggestions to build a mid bass driver box (horn loaded?), then set the amps for the proper x-over points to get an even flat response.
Alternately: I'm willing to get dBX drivereack 260 to help time align the output on each channel will have its own set of amplifiers for every two speakers
All of these were part of the museums electronics before they went IMAX.