View Full Version : Altec Lansing 9444B amp as a 70V system
CarterWeb
04-14-2007, 11:40 AM
Greetings, The speaker outputs of the 9444B amp in bridged mode states 600W/8ohm, 70VRMS. I need to power 6 speakers tapped at 60 watts and wired in parallel. What do I need the do this (a 400-600 watt 70Volt output transformer}? The speakers have an 8 ohm bypass but that puts the total impedance at 1.6 ohms (if I did the calculation right).
Thanks, CarterWeb
moldyoldy
04-14-2007, 05:46 PM
Greetings, The speaker outputs of the 9444B amp in bridged mode states 600W/8ohm, 70VRMS...
The integral 8 ohm output voltage just happens to be 70V under fully-driven conditions, the 9444B is not a 70V amp.
For distributed systems, you will need to add a step-up xfmr, Altec part number 15525A (70V-300W) or equiv. Hookup details are in the manual, at;
http://www.altecpro.com/pdfs/vintage/ElectronicsAndTransformers/powerAmps/9444B%20Power%20Amplifier%20Manual.pdf
There's a 15525A on eBay at the moment (no affilliation or endorsement);
http://cgi.ebay.com/Altec-Lansing-600watt-70-7volt-Transformer-Model-15525A_W0QQitemZ270109136638QQihZ017QQcategoryZ237 94QQcmdZViewItem
CarterWeb
04-15-2007, 03:14 PM
Hey...Thanks so much for all the information! I think that answered all my questions. Now, off to eBay!
Thanks again!
CarterWeb
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.