JBL 2245 Ideal enclosure

[A Vanderkruk]

Hi Lee, thanks for interst, I have a preliminay drawing that my freind Dieter made of it but it is not competely dimentioned , I could get him to finish the dimentions as they are now. It was one of the more simple cabinets I have made as all the interior panels are the same width so you just rip your plywood all at once. i made it to cut nicely from 5x5 sheets baltic birch 18 mm 13ply , no screws, all bisket joints (200 in all)
the matierials are 3 sheets 5x5 18 mm baltic birch AA-AA grade , each cabinet so 6 sheets for pair. The horn starts under the driver and scrolls around the compresion chamber. The interior throat section is made with my sand composit and requires a mould made of that. I didn't take any inside or building pic.
I will be building two more and I can take some inside shots then.
here is a preliminay drawing ,,, "Bentwood Goliath Horn" siesmic warrior
Oh and the drivers are new factory fresh cones , my neighbor was owner of the local JBL dealer so I got the real mccoy

[Lee in Montreal]

I am curious. How long is the horn path? 7, 8, 9 ft long? Throat to mouth.

BTW I am not persuaded the recone is a JBL one. The tinsels' length are the giveaway. They are too long. But hey, if it sounds fine, then be it... ;-)

[A Vanderkruk]

Hi Lee, Horn is 11 ft on center of the horn path,
Oh and pretty sure they are genuine JBL cone I got them at the JBL dealer in sealed JBL boxes and put them in myself so no mix up i'm sure, but thanks for the worry's. if they are not real then i paid $300 too much each

[A Vanderkruk]

Driver picture, I don't know, maybe somone know's if this is how the cones are identified , looks real to me