Results 1 to 3 of 3

Thread: 4645C Amp question

  1. #1
    Member
    Join Date
    Nov 2005
    Location
    MN
    Posts
    35

    4645C Amp question

    Can I use a regular amp with LT & RT outputs to drive one sub? How would I wire it and does the 4645c have a built in cross over?

  2. #2
    Senior Member duaneage's Avatar
    Join Date
    Jan 2005
    Location
    The First State
    Posts
    1,585
    It really depends on the amp. Some amps can be run in mono, others can be run as a bridged amp if you invert one channel on the input. In english that means one channel is normal polarity going in and the other is out of phase before it goes in. Of course you need additional electronics to do that and an electronic active crossover will do that (maybe)

    I would get a mono plate amp from parts express. They are not too expensive, have built in crossovers, and are really what you need to power a sub easily

  3. #3
    Senior Member grumpy's Avatar
    Join Date
    Oct 2003
    Location
    SoCal
    Posts
    5,742
    It does not have an internal crossover:
    http://www.jblproservice.com/pdf/The...ries/4645C.pdf

    You should be using an external crossover (electronic, not passive)
    with sub-bass rolloff, and a high quality amp with enough power to suit
    your room/environment. Then you'll have enough bass to loosen your bowels.

    Whether you bridge a dual channel amp or not is your call (should be based on your
    knowledge and experience, as improper bridging can damage things).

    -grumpy

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. tube bi amp 250ti advise
    By gerard in forum Professional Amps
    Replies: 2
    Last Post: 10-16-2005, 06:42 PM
  2. Two sets of Speaks, One amp
    By Mitch Noble in forum Lansing Product Technical Help
    Replies: 11
    Last Post: 10-11-2005, 08:11 PM
  3. Non-Searching Newbie Question solution?
    By Regis in forum Forum Feedback
    Replies: 7
    Last Post: 05-04-2005, 07:12 PM
  4. 250 Ti Biamp ( one or 2 amp ) ?
    By gerard in forum Lansing Product Technical Help
    Replies: 1
    Last Post: 11-29-2004, 11:10 AM
  5. QSC A5.1 amp question
    By Figge in forum Professional Amps
    Replies: 6
    Last Post: 10-13-2004, 01:04 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •