Orig. owner L100T, with van den Hul mono crystal silver in the networks, Tiffany binding posts, all connections soldered.
recently (last couple of years) acquired mint:
18Tis
L46s
L1s
Orig. owner L100T, with van den Hul mono crystal silver in the networks, Tiffany binding posts, all connections soldered.
recently (last couple of years) acquired mint:
18Tis
L46s
L1s
4208,Chinese made 4612,4628b,4698B,L80(euro)
46 lover
I currently have a pair of L100 Century (123A-1, LE5-2, LE25).
Also 4343 in grey utility cabs and L100S that await new surrounds for the 2214H's.
In the past I owned the 4311A, 4311BWX and XPL90.
Now that the big JBL clean out is over, here's my current state of JBL deprivation.
- JBL Simply Cinema 5.1 HTIB
- JBL L100 Century, two pairs
- JBL SAM2LF (single)
- JBL SAM1HF (single)
- JBL S4HC (single)
- JBL PC600 (single)
- JBL W15 GTI pair (not listing the numerous other car and home individual drivers)
- JBL S4Ai (three or four)
- JBL PT800, two pairs
- JBL 4645C pair
- JBL XPL200A + DX-1, bi-amplification
- PT250 pair with JBL L250 cabs, LE14-3, 908Ti, 904Ti, and 044Ti drivers, BSS 366T speaker management systems in four-way active crossover, quad-amplification*
- Timbers Array pair, 1200Fe, 435Be, 045Be*
- Timbers Array pair+ DX-1 and Parasound P7, 1200Fe, 476Be, 045Be, tri-amped* with JBL S2S subs
- JBL LSR308 pair
- JBL K2 S9900 pair, with bridged S800 amps
- JBL Synthesis One Array 7.1 system
* NOT official JBL products but full of JBL parts
I'm not suffering too much.
Out.
2405 tweeter
2440 compression driver
2390 hartsfield lens
e145 woofer
No complete operating JBL systems...but I have some interesting parts!
I have a complete single channel stuffing kit, new OLD STOCK in boxes, for a Hartsfield...including an 075. this includes the 150-4 woofer, the 375, the horn, the huge lens, the crossover, and an 075. This might end up being built into a center channel for a cinema system. Yup, new in box! complete with stiff aged surround on the woofer. I would hate to think I need to re-cone it due to stiffness, but it could be a reality. Any ideas for a non-Hartsfield cab project would be appreciated, especially as a dialog center channel where it will not be asked to go really low.
Also have a pair of good D-130 frames that need re-coning [ thanks to a momentary DC offset that burned out the Voice Coils last year]
1 each OLD style D130 basket with solder terminals, needs cone
1 each D140 basket, needs cone
1 each Altec Lansing branded basket, no cone, similar to D130 except magent is not rounded at rear edges..I need to look at the basket to get model, if it has it listed.
Also have a nice pair of 175s, conical horns and the rectangular lenses...one of the lenses was slightly broken. DRAT! I have my eye on a pair of 1 inch throat JBL bi-radial butt cheeks, and if I am able to buy them, the conical cast aluminum horns, and their rectangular lenses, will be avaialble.
There are also some consumer JBL woofers with stamped frames out in the collection, 12 inchers as I recall
At one time Ampex was using a pair of the 8 inch JBLs in thier 'suitcase' portable monitor system. I recently bought such a suitcase system, but have yet to open them up to see if they have the JB, or the other cheaper driver Ampex used later on.....wish me luck!
Jennifer
L300, Harkness with 001 load.
4350
4311
4311wxa
4301
4401
Apollos with 030-D131version
DD66000 in the main room
1400 Arrays with 880 Array as LCR in my HT
Century L100s in the office
...and I still want more!
Widget
4408A and L1's in the office (switch between them)
4410A in the lounge
4642A; PT800/PS1400 (stacked pair) x6 + PC600/PS1400 (not linked but sat on top of the other for centre) for HT in the basement
Enough Raw Drivers to build pair of 4355, pair of 4345 and two B460's (slowly building up my woodwork tools and skills to do them)
Like Widget said, I too still want more...
Let's see if I can remember them all to update my list:
4345 clones in Kenrick black-ash-baffle cabinets from New Zenith in Connecticut
030 in C35 and/or C37 cabinets (take your pick) Original mono system purchased by my Father in 1957. Second added 1969.
L150A bought 100-miles away (thanks Don Mascali)
L112 I bought "for my wife" brand-new for our first anniversary 31-years ago
L96 purchased from member here when no one else wanted them, in perfect condition w/factory re-cones, 100-miles away
L7 bought three-houses down the road
L7 bought 100-miles away
L5 bought in Boston (thanks spwal)
L3 bought 70-miles away
L1 new-in-box bought in DC area, delivered by seller to my sister-in-law
L80T (CL purchase in NC while picking up a rare motorcycle) later converted to T3 x-overs
L80T (CL purchase locally with new woofers installed by JBL dealer) later converted to T3 x-over
L20T delivered to me in Virginia by Heather and Emma!
L26 (cheap off eBay) pony-express delivery from SC by a friend
4412A eBay purchase shipped to me cheap
LX22 (CL purchase locally advertised as LX55 because that's how they're labeled!)
Pro-III Plus (with subwoofer) off CL four-miles away, for lunch-money
2600 (free off Freecycle six-houses down the road)
I think that's it.
". . . as you have no doubt noticed, no one told the 4345 that it can't work correctly so it does anyway."—Greg Timbers
I'm down to two pairs now, L300s up front and L80T's in the rear.
My list :
4343
4311B
SG520
2121 (pair)
1308 lens (pair)
5234A with 4343 cards
Wanted list:
SE400S (twice owned but returned due to some issues)
SA600
4345
I still want more vintage JBL gear!
There are currently 1 users browsing this thread. (0 members and 1 guests)