Results 1 to 2 of 2

Thread: 2204 recone in 2203

  1. #1
    sa660
    Guest

    Question 2204 recone in 2203

    Can the JBL 2206 or 2204 be recone with the 2203 cones?

    I would like to build a small home studio cabinet with 2x2203. I believe this model can offer very deep bass in a very small volume (2 cu-ft- 57L).
    I would like to compliment this dual 2203 with a single 2" 2450 for the mid and high frequency. any advice on the horns that I should use for the best flat response from 500 to 18Khz.


    Your help is welcome.
    Thanks,

  2. #2
    Obsolete
    Join Date
    Apr 2003
    Location
    NLA
    Posts
    14,548
    The 2204 can be reconed as a 124/2203 but i'm not sure about the 2206. The 124/2203 works great in a 2.5 - 3.0 cubic foot enclosure tuned to 30 - 32 Hz. In a 2.0 cubic foot enclosure tune to 26 Hz or 40 Hz and see which you prefer. The old JBL tuning frequency for this transducer was 26 Hz but in practice that was usually way too low. The Qts is extremely low at 0.14 (which hints at it's extremely powerful motor).

    ---------------------------------------------------------------------------

    The old JBL enclosure chart had the following two recommendations for the 124/2203:

    1.6 to 2.0 cubic feet with a 3" (7 sq in) port having a 8" duct
    2.1 to 3.0 cubic feet with a 3" (7 sq in) port having a 5" duct

    In both cases the Fb was ~ 32 Hz which wasn't in agreement with the user's guide which was, as previously stated, 26 Hz.
    Last edited by 4313B; 04-25-2003 at 11:07 AM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 2203 Subs
    By Guido in forum Lansing Product DIY Forum
    Replies: 46
    Last Post: 10-09-2017, 09:42 AM
  2. Another JBl recone question.
    By scott fitlin in forum Lansing Product Technical Help
    Replies: 7
    Last Post: 08-15-2006, 09:01 AM
  3. Searched to no avail - where to get 2203 recones?
    By cgaither in forum Lansing Product Technical Help
    Replies: 1
    Last Post: 12-29-2004, 05:00 AM
  4. Recone le10 to 2123 - le15 to xxxx ?
    By gerard in forum Lansing Product Technical Help
    Replies: 12
    Last Post: 11-07-2004, 03:12 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •