N500C Network Divider

[mvrandazzo]

Hello All,
I ran across this forum doing research on an Altec Lansing array installed in a theater. It was disconnected for an unknown reason. I would like to get it going and I am looking for documentation on the N500C network divider. It is connected to 4 288C drivers and 2 15" cabinets that are unknown. I temporarily hooked it up to an 8 ohm source to see if it still works and it sounded great. However, I did not leave it hooked up for fear the impedance is incorrect. I found some info on the N500F but I don;t know if it is the same as the N500C. Is there a schematic on the N500C.

Thanks.
Mark

[jcrobso]

http://alteclansingunofficial.nlenet...ers/TL_121.pdf

[kstlfido]

I just came across one and needed the schematic to check it out. Thanks for the link!