Hi everyone, I've a project to copy a 2344 horn with a 3D printer. So any comments or ideas are welcome. I've already built a 4330 clone cabinet, my problem is find the horn.
regards
Richard
Hi everyone, I've a project to copy a 2344 horn with a 3D printer. So any comments or ideas are welcome. I've already built a 4330 clone cabinet, my problem is find the horn.
regards
Richard
I have to think that the 2344a horns must not be that tough to find or that costly to purchase if you can wait. Maybe someone on the forum has a spare set?
Widget
Are you doing a 3D copy because you can’t find a pair used, or just because you like a challenge?
Ha - jinx Widget
That the internet contains a blog documenting your life does not constitute proof that your existence is valid. Sorry.
Try Jamin Jersey
Hi, thanks ,I've found a pair on jammin site at 200$ each.
That the internet contains a blog documenting your life does not constitute proof that your existence is valid. Sorry.
Hi HCSGuy, do you have the two parts version or one part for the 2344?
and by the way is for both reason
Bad news - I looked for about an hour and a half, and couldn’t find them. Out of desperation, i went through my DM’s on this site, and found that they’ve already gone to another member on the forum and I’d forgot. So sorry for the senior moment…
That the internet contains a blog documenting your life does not constitute proof that your existence is valid. Sorry.
I was looking at the Humble Hifi site and noted a project that seems to use a JBl 2344 with a 12-15 inch woofer… attractive looking speaker …take a look.
There are currently 1 users browsing this thread. (0 members and 1 guests)