Hallo All
I have a question I hope you help me answer, over the past years I have been collecting drivers to make a JBL 4344 clone.
Now I have all the drivers and the cabinet are in the process of being made,
The Drivers I have is
Low: JBL 2235
Mid: JBL 2123
JBL: 2426
JBL 2404
So now the only question left is what crossover to run with, I have been searched the internet and read a lot of treads to find the best option for the crossover.
Hallo All
So now the only question left is what crossover to run with, I have been searched the internet and read a lot of treads to find the best option for the crossover and until now I have found 3 options
Option 1: As I understand the Charge Coupled Crossover (below schematic) is good, but it has a lot of big capacitors with large values, which are quite expensive if you want to buy them in a good audio quality
so before I use all my saved up money on this. I hope you will guide me
Both option 2 and 3 are somewhat cheaper to make as the values on the capacitor are lower that option 1, so if I go with option 2 or 3 I also have the ability to buy better components.
Option 2: __Ver 2_2_AVT 4345 Bi-Amp:
Option 3: JBL 4344 Xover Schematic
Option 4:? Is there any crossover that I have missed?
I hope that someone on this forum will help me out, so I can make the decisions and move on
BR
Manley