Results 1 to 3 of 3

Thread: How To Remove Mid Driver From L110A

  1. #1
    Junior Member
    Join Date
    Nov 2020
    Location
    toronto
    Posts
    24

    How To Remove Mid Driver From L110A

    The midrange drivers in my L110As won't budge. I have removed the bass driver and the tweeter without difficulty, how do you remove the mid driver?

  2. #2
    Senior Member HCSGuy's Avatar
    Join Date
    Jan 2009
    Location
    Bend, OR
    Posts
    698
    Iíve always done it with an angled pick through the screw holes, or even prying with a small slotted screwdriver. If I remember, the drivers donít have a bevel to the back edge of the frame, so you canít shove a plastic paint scraper in, and anything else shoved in the side will probably mar the finish of the front of the cabinet. Screw holes are your only option, I think. You might also try laying the speaker down on its back, putting a dry washcloth to the side of the driver, then use a 1ft long piece of 1x4 or similar against the side of the driver frame, and hit the end of the 1x4 with a hammer to knock the driver free from the paint. Obviously, this assumes the screws have all been removed. Also, sometimes youíll run into one where the driver is really tight in the hole, so knocking it will do no good, as there is no where for the driver to go. Hope this helps...
    That the internet contains a blog documenting your life does not constitute proof that your existence is valid. Sorry.

  3. #3
    Senior Member BMWCCA's Avatar
    Join Date
    Feb 2006
    Location
    Virginia
    Posts
    7,220
    Gentle application of heat gun or hair dryer has worked for me on stuck drivers.
    ". . . as you have no doubt noticed, no one told the 4345 that it can't work correctly so it does anyway."óGreg Timbers

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. JBL L110A refoam and stands
    By vrobec in forum Lansing Product Technical Help
    Replies: 20
    Last Post: 03-01-2021, 03:42 PM
  2. L110A 033 Replacement Queries
    By scroogemcdov in forum General Audio Discussion
    Replies: 15
    Last Post: 12-26-2020, 03:24 PM
  3. Problem with Toltec inductor on L110A?
    By tstrobaugh in forum Lansing Product Technical Help
    Replies: 0
    Last Post: 10-30-2009, 10:49 AM
  4. Difference Between the L110 and the L110a
    By LRBacon in forum Lansing Product General Information
    Replies: 4
    Last Post: 10-26-2007, 12:45 PM
  5. How to Remove Driver from Cabinet
    By atdamico in forum Lansing Product Technical Help
    Replies: 13
    Last Post: 04-12-2006, 05:53 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •