Originally Posted by
mhershey84
I got a chance to switch the crossovers last night and the issue followed with them so I guess I'm building new crossovers. I did find a schematic of the N800F, but I'm a little confused as this is my first time building anything audio related. From what I read, this circuit used a 25 ohm pot instead of an L-Pad. I did find a few references stating that a 16ohm L-Pad could be substituted, but I wasn't sure if I then should remove the 20ohm resistor or is that should be included still. Here's the part list I put together so any advice would be appreciated.
Dayton Audio PMPC-4.0 4.0uF 250V Precision Audio Capacitor
Dayton Audio PMPC-10 10uF 250V Precision Audio Capacitor
Jantzen Audio 3.5mH 18 AWG Air Core Inductor Crossover Coil
Dayton Audio DNR-20 20 Ohm 10W Precision Audio Grade Resistor
Parts Express Speaker L-Pad Attenuator 100W Mono 3/8" Shaft 16 Ohm