Good day all,
I have a stock pair of 4345. Currently I am running an electronic JBL 5235 urei crossover with the 4345 cards. Both high-range and low-range going through it.
Recently picked up a Minidsp SHD. It has 4 analog outputs for bi-amping and I can digitally setup the crossover points.
How do I set up crossover?
For low pass I found the recommended 310hz cutoff with a LR 24dB/oct filter. Going to the low range amp.
But what about for the high-pass section? Or should I just run it full range into the 4345 high-range?
Any help will be much appreciated. I am quite young and inexperienced, but this is so exciting falling down the JBL rabbit hole.
After this I will be running Dirac room correction through the SHD with the minidsp measurement microphone. Any other useful softwares to conduct measurements?
Reply With Quote
