Results 1 to 4 of 4

Thread: Best Way to Remove 14 LEH-1 Woofer from L250 Cabinet

  1. #1
    Member
    Join Date
    Jan 2007
    Location
    Florida
    Posts
    32

    Best Way to Remove 14 LEH-1 Woofer from L250 Cabinet

    Removed the 4 screws and tried to remove the woofer but it's in there pretty solid..I definitely want to avoid damaging the cabinet...Any tricks I need to know? Thanks!

  2. #2
    Senior Member SEAWOLF97's Avatar
    Join Date
    Jan 2006
    Location
    PDX, ®egon
    Posts
    9,103
    when I removed mine from the 250Ti's, the LE-14's were stuck too.

    from experience, I removed screws, rolled up a big towel (abt 6 inch thick roll) ....placed it under the face, but close to the top of the cabinet (cab now resting face down on the rug). Gave it about a 4 inch lift and drop.
    The towel cushions the drop and spares the tweeter, and the woof just keeps on going.

    it will be face down on the rug when you put the cab back upright.

    you may have to reach under the cab and pull wire leads before righting cab.

    no need to reverse procedure when re-installing
    “If you think that’s the dumbest thing you’ve ever heard,
    just wait a couple minutes!”

  3. #3
    Senior Member rdgrimes's Avatar
    Join Date
    Aug 2008
    Location
    New Mexico, USA
    Posts
    2,172
    The port is centered right over the LE14 magnet, so you can easily reach in and give it a thump.

  4. #4
    Senior Member
    Join Date
    Feb 2018
    Location
    Annapolis, MD
    Posts
    172
    I seem to recall loosening the screws that hold the driver but not removing them so I could push the driver out (via the port hole in the rear) without it dropping on the floor.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Weight of an empty L250 cabinet?
    By Doc Mark in forum Lansing Product General Information
    Replies: 5
    Last Post: 10-16-2014, 11:12 AM
  2. Side woofer cabinet
    By gerard in forum Lansing Product DIY Forum
    Replies: 3
    Last Post: 10-01-2008, 03:13 PM
  3. How to Remove Driver from Cabinet
    By atdamico in forum Lansing Product Technical Help
    Replies: 13
    Last Post: 04-12-2006, 04:53 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •