Diy 4315

[bldozier]

Kits arrived from Vista, found a cabinet maker
from US Audio Mart.

Im pleased. The 2105 cut out at 4 3/8 seems
spacy, buts it’s the same on the L88 plus

i will assemble soon

[bldozier]

The L100t sub enclosure for the le5 is to
large in diameter for the 4315s, I had ro
remove the sub-enclosure from the l88 plus
which fit perfect, the l88 plus can also
utilize the larger L100t enclosure.

The carpenter cut the rear cut out for the
terminal plates to large for the original
3114 plates, so I’m using 1/2 B.B.

[bldozier]

So far every joint is gaping, the bottom and tops are
not flush with the sides I would not
be able to veneer them w/o sending out
to a professional shop first to flush everything up

i paid $800.00, $500.00 for the cabinets & $300.00
flat packed from Cali,

im asking for the seller cut all panels again
and ship on his dime, or return $600.00

X#2 on the 4315 cabinets

[bldozier]

i honestly feel the guy whom made these
did not test fit the cabinets, I’m not sure
how these got delivered in this condition

when end I asked for a test fit the response was
the joints were to tight and would not separate
bur was assured fit was perfect,

the carpenter had these in his shop for 5 months
my last day to file a claim on them is the 31st of October

[macaroonie]

That's a piss poor job. I'm amazed that you couldn't find a wood fabricator locally , that would have been better.

Can I make a suggestion , get yourself one of these



and offer it up against the corners that should be 90 degrees. You will be able to take pics of that that will confirm your case.

Also if you measure diagonally both ways across a suspect panel if it is square both measurements will be the same. If it is skewed the measurements will be noticeably different.

[bldozier]

the baffles are fine, all other panels on these cabinets
are problematic, I asked for the panels to be resawn
tested and shipped to me,

the next offer i fer I had was one from Canada
$750.00 no veneer plus whatever shipping is from
there,

$1000.00 from a Lansing member, plus the shipping
charge. I’m over $1000.00 already on two failed attempts
on cabinets

honestly I’m just not quite sure how these were mailed
to me after 5 months of construction