Very nice. Inspirational, in fact.
I -really- need to make working space in the garage and get going before George comes and kicks my butt!
Very nice. Inspirational, in fact.
I -really- need to make working space in the garage and get going before George comes and kicks my butt!
Wow, they're pretty. The sounds probably as good as the look,
How did JBL fasten these tweeters in the 4345's? Did they drill blind holes into the baffle's back and use propel nuts?
Btw, splendid craftmanship, to both !
Best regards!
Hi Kay,
The 2405 UHF driver, http://www.jblpro.com/pub/obsolete/2405.pdf [sorry, wanted to use a picture but it's the next best thing ] was put into the cabinet
from the inside and the four mounting screws inserted from the front to screw into the square mount plate. The ones you can see in/near the rounded corner
plate. The HF Horn's were mounted in a similar fashion. Hope this helps.
Kind Regards,
DogBox [steve]
Of course it does, Steve !
Then the wrong holes (by atisley) might be interpreted as too large in diameter or in the wrong places, I assume?
Best regards!
I love seeing all these 4345 builds. I'm curious as I've seen a few mentions of them... Are there a set of CAD drawings or files for CNC available online? Or are all of these CNC builds from one off sets of plans?
EDIT: found them. Apologies.
Great build. Love the veneer you folks are getting too. Great grain and figure.
There are currently 1 users browsing this thread. (0 members and 1 guests)