I plan to post a bunch of cone sets and plan to include a picture of the DC resistance reading.
I have a L8RLE52 cone and can’t get a steady reading. Just tried a D16R2420 and the same thing happens.
I have alligator clip type probes so I am getting a good connection to the coil leads. I put a fresh battery into my Fluke 77. Just sitting on the table the reading changes from 5.7 to 6.3 ohms. I shorted the leads and the reading varied from 0 to .2 ohms. I am using Fluke test leads and Fluke probes.
1. Is the DC resistance important to selling cones?
2. Is this varying reading normal at low values?