It look´s like 2269G/H are very good driver with very low THD
http://www.audioheritage.org/vbullet...hp?22679-2269h
I have not seen the THD for W1500H
I think at both 2269G/H and W1500H will have similar low end
W1500H can do that in smaller enclosure
2269G/H will of course play louder
http://www.jblpro.com/www/products/r...8#.WkSu6Lp2uUk
http://www.jblpro.com/ProductAttachm...heet060717.pdf
DD + neo is newer tech than SFG + ferrite. That's not up for debate.
More importantly for the context of my recommendation, it's the same motor tech as the woofer in the OP's mains.
And if the OP planned on matching subs with E2 or K2, my recommendation would've been opposite...
That said, earlier this month I was in NYC for work so I visited the Harman Store on Madison. They had a basement room with a full Levinson rig that drove either Revel Salon 2 or JBL K2. So I was able to A/B them. I was genuinely surprised how much better the Salon 2 sounded than the K2. Much more spacious, much cleaner midrange, airier. No less punchy, either.
They're treating me very well Calibrated the system this weekend and I think the result so far is very good. They are articulate and reveals all nuances in the bass. They do sound different than my previous S1S-EX subs especially below ~40hz where they are more dynamic and more "controlled". The impact is scary.
I cross the M2s and SUB18s at 80hz and it sounds like a complete system. Not "speakers and subs".
Sub18 specially if you are using the M2
their is a special setting (harman ) if you are using dci cdi or itech amps
Where do you find SUB18 settings? I'm using BSS Soundwebs. But I could replicate from the DCi settings if needed
Look inside the files
there you will find for the M2 and also for the Sub18
There are currently 1 users browsing this thread. (0 members and 1 guests)