Couple questions about cleaning up my L200Bs

[Johnny_Law]

Well, shortly after my L200Bs followed me home, I picked up my L250s, so all of a sudden I ran out of any urgency to get the L200Bs going again. I'm finally doing it - basically just cleaning everything and refoaming the 136As - and have two questions.

1 - What's the best way to clean the surface of my 136A cones? They are extremely dusty and I'm afraid of using the wrong method and damaging or discoloring the cones.



2 - One of my ports has a little bit of damage to the cardboard. Is there a best practice for fixing this?



And here's a shot of them just because.



Thanks in advance,
Ryan

[richluvsound]

compressed air .....

[Mr. Widget]

compressed air .....

Gently... I’d follow up with a soft towel that is slightly damp.


Widget

[grumpy]

re port, I’d just use white glue, sand lightly if needed, and touch up the paint ... also if needed. All just to keep it from lifting further.

[Johnny_Law]

Thanks all. Will proceed with caution.

[Johnny_Law]

Haven't touched the cardboard port yet, but looking good.

[grumpy]

There has to be a Moet & Chandon in there somewhere

[Mr. Widget]

Haven't touched the cardboard port yet, but looking good.

Damned pretty! I'm envious!

Keep us posted.



Widget

[Johnny_Law]

Nestled in.

[Audiobeer]

They look beautiful Johnny. Be careful with the sun. I've seen the Patina change on a cabinet when the sun its it every day and no where else on the cabinet. Two tone. That being said you have some nice gear. Can I ask what your address is and when your are usually not home?

[Johnny_Law]

Thanks

If you are ever in the North Bay area California you're welcome to swing by for a cocktail!

[Johnny_Law]

Update, after listening to them for a while, I'm shocked at how good they are. I thought I would run quickly back to my L250s, but that hasn't happened. The LE85 is really, really nice. The 136A is really clean sounding, but can also dig deep and deliver a punch.