Results 1 to 2 of 2

Thread: Questions about the Ashly XR1001 Active Crossover

  1. #1
    Senior Member porschedpm's Avatar
    Join Date
    May 2004
    Reno/SF Bay Area

    Questions about the Ashly XR1001 Active Crossover

    Hi. I recently installed an Ashly XR1001 as the crossover portion of my bi-amp set-up running a pair of 4345's. I'm crossing these over at 300hz (as close as I can tell anyway since the Ashly's crossover knob doesn't have a hash mark at the 300 point). I have a couple of questions that I'd like to throw out to those using the Ashly XR1001 with 4343 or 4345 monitors:

    1) What's settings do you prefer? mine are set at:
    Output Level, low: 5 (Unity)
    Output Level, high: 6
    Response: 4
    Crossover freq: 300
    Input level: 5 (Unity)

    2) I thought I remember reading that the Ashly has a 24db/octave crossover slopes. If phase is changed when using a 24db/octave crossover, do I need to change the reverse my speaker leads so that the red speaker wires now goes to the black speaker terminals on the back of the 4343? Or am I reading too much into phase debate?

  2. #2
    RIP 2011 Zilch's Avatar
    Join Date
    Jun 2004
    Berkeley, CA

    It doesn't matter.

    24 dB is four poles, and throws everything 360 degrees out of phase, i.e., back IN phase.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Ashly XR1001 Active Crossover
    By boputnam in forum Electronic Crossovers
    Replies: 156
    Last Post: 10-06-2009, 09:58 AM
  2. JBl XPL 160 and active crossover
    By glarre in forum Lansing Product Technical Help
    Replies: 4
    Last Post: 10-18-2004, 08:07 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts