I have a Electrovoice DX38 so I can just bypass the switch and go straight to the woofer with the low freq. Do I have to do anything with the mids and highs?
I have a Electrovoice DX38 so I can just bypass the switch and go straight to the woofer with the low freq. Do I have to do anything with the mids and highs?
Hi, I'm not familiar with that EV unit. Can you adjust the crossover point and slope?
So This is how I do it on my 4343's:
-I use a First Watt B4 active crossover which allows me to set crossover points and slopes and slip the signal into a high pass and low pass
- The crossover point for the 4343 LF is 300hz and 12db per octave slope.
- This is optional: That biamp switch is nasty and degrades the signal. Now I have no intent of going back to a single amp so I totally disconnected the biamp switch. i did this by flicking it to biamp mode and tracing where all the connections went, then desoldered the wires from the switch and connected the wires up again directly to each other as the switch would have. You can also do it by leaving everything attached to the switch but adding little jumper conductors so the signal doesnt have to rely on passing through the contacts.
- I was able to have the low freq signal go directly to the woofer because in the 4343 in biamp mode it just flicks the LF signal directly to the woofers. Not sure if thats also the case on the 4345.
Hope that helps
Yes you adjust the high low crossover points and the slope on the Electovoice DX38. It is a 24 bit machine and I like it a lot. Greg at Home Audio Sound turned me on to it and he recommended it to me and I'm glad he did. I bough it the same time I got the 4345s and McIntosh Mc2500 from him and everything turned out wonderfully. You can adjust the time also which is handy if you want to run subs. I think to weak point of the biamp switch is the contact of the pins so I would jumper over them.
Welcome.
You could start here where the system's designer suggested:
"Get rid of the bi-amp switch. Hardwire it in which ever mode you want it. The switch is not that great.
". . . as you have no doubt noticed, no one told the 4345 that it can't work correctly so it does anyway."—Greg Timbers
I just finished one of my 4345s and the other is still stock. It is so much better without the switch. Thanks Ian for your help. I also bypassed the L-pad with resisters on the mid filter which showed me how much I was missing using the L-pad. I left the high and ultra high through the L-pads for now because is gives me more flexability and it seems to be less of an issue on my speakers.
Cool
There are currently 1 users browsing this thread. (0 members and 1 guests)