Advice on replacing binding posts on 250ti

[bradster56]

Time to replace the stock binding posts on my pair of L250ti
Any suggestions?

[Audiobeer]

Time to replace the stock binding posts on my pair of L250ti
Any suggestions?

Try these

[bradster56]

Try these

Thanks..I'm also looking at Cardas and WBT

[svollmer]

Parts Express has a good selection. They have WBT as well as their in-house ones that look similar to WBT.

http://www.parts-express.com/cat/binding-posts/1506

[brutal]

Worth looking at this site http://www.soniccraft.com/index.php/...a54a5223126b0a

I've dealt with them many times in the past on Vampire Wire and Cardas posts. Good prices and service.

[bradster56]

http://www.soniccraft.com/product_in...ng-post-p-1669

Thanks All...looking at these binding posts and wonder if there would be any installation issues..

[Swerd]

http://www.soniccraft.com/product_in...ng-post-p-1669

Thanks All...looking at these binding posts and wonder if there would be any installation issues..

Before you buy new binding posts, remove the old ones and make sure you know the diameter and length of the shaft that goes through the mounting plate. Unless you want to drill new holes, order new posts that fit your existing holes and aren't longer than what you need.

What is wrong with your existing binding posts? Do they look like these?

[BMWCCA]

I suspect it looks more like the ones in this thread: http://www.stereo.net.au/forums/topi...tor-brigade-d/

[bradster56]

Yes they are ones in the last post...35 yrs old now and not exactly state of the art

[Dr.db]

Worth looking at this site http://www.soniccraft.com/index.php/...a54a5223126b0a

I've dealt with them many times in the past on Vampire Wire and Cardas posts. Good prices and service.

I have bought my Cardas posts there as well.
Pure copper and gold plated...

[SEAWOLF97]

My 250Ti's posts would not accept 12 ga. wire . I contemplated enlarging the wire pass thru hole, but in the end I just used banana plugs. works fine.