So I am putting the mass rings in two of the 2234's I used during the re-surround job on my 4435's and didn't end up with a glue line I was happy with so I cut the cap back off and re did it.
I was in the process of flattening the old adhesive with a 90 degree die-grinder on the other one and when I let off the throttle, the Roloc wasnt locked and spun off the mandrel. Where did the disk go? Right accross the other 2235. Damn the luck!
There is an obvious lesson here.
I am writing this while I wait for my adrenalin level to go back down so I can sleep.