I need to fabricate a replicate L212 Ultrabass grill cover. I can reverse-engineer it, but just to be sure, can someone please tell me its dimensions, in particular how thick it is? Also, is it MDF? Photos would be great. Thanks.
I need to fabricate a replicate L212 Ultrabass grill cover. I can reverse-engineer it, but just to be sure, can someone please tell me its dimensions, in particular how thick it is? Also, is it MDF? Photos would be great. Thanks.
It should be 16, 7/8 wide and 18, 1/8 tall, made from particle board 15/16 thick. It would be sized to fit into the recess at the front of the cab.
Thanks, Don! Is there a recess or groove (rabbet or rebate) around the edge? Do you know the hole diameter? If not, I'll just make it maybe 1/2"+ larger than the woofer frame.
Now, on to find that strange fabric.
Bump: Still hoping for photos of the back of the subwoofer grill. And does anyone know of a source for the unique grill cloth? Thanks!
Thanks so much, mate! Much appreciated! Actually, based upon the peg holes and driver opening, that's gotta be right-side up.
And below is the grill fabric.
(PS I always wanted to say "mate". )
No cloth source yet, but I'll update this thread if I find some. Thanks again, mate!
It looks like guitar cloth.
http://www.mojotone.com/Grillcloth_x#/
DIY Array, 2242 sub, 4408, 4208, Control 8SR, E120 Guitar cab, Control 1, LSR305.
I thought so, too. I'll check out the cloth on my sons's Fender amp.
There are currently 1 users browsing this thread. (0 members and 1 guests)