I`m going för building a M2-clone or in style of I found the horns and modified plates second hand in Sweden. (what is the chance of that). The rest I will get from speaker exchange.
I have some serious problems of deciding what amps or DSP to use. I think I will go for BSS or crown because simplicity with presets. I have a alternative to a nice price from a friend to buy a Crown CTs 8200 with integrated BSS-dsp. But I`m not sure if it is powerfull enough. It is 8ch and the plan is to bridge four channels for the 2216nd`s. The 2216 is a 6ohm driver. The CTs is not specified fo loads under 8ohm bridged. It leaves 4-500RMS per channel bridged. http://www.crownaudio.com/media/wysi...nel_USP-CN.pdf
My other 3 times (at least) more expensive alternative is a Crown 4x3500.
I like to play loud some times.
Today I run 18" subs. I hope to not be needing any subs whith my M2`s. Therefore I`m unsure if the CTs 8200 will be enough.
Where is the limit in RMS set on DSP in the Crown HD amps? 1000rms?
Plan 3 could is to get the CTs and use it`s dsp for a bigger amp thru the cobranet.
Plan 4 external DSP and use my Lab.gruppen amps
Suggestions?
Best regards
Karl