Hey, I need someone to do a little measurement, to settle a discussion here.

Anyone who has a loose 2234 or 2235 kit (new or used), PLEASE take a ruler or tape measure, and measure the HEIGHT of the voice coil former (along the travel), from the top (in front of the cone) to the bottom (at the very back of the windings, toward where the backplate goes). If the coil was sitting on a table, flat, what I need is the height that it sits above the table, in essence.

I'm pretty sure it should be about 1.150" (between 1 1/8" and 1 3/16"), but there someone here that seems to insist it should be 1 3/8". AFAIK, a 1 3/8" coil wouldl not fit under the correct dustcap (which is about 4 1/8" diameter)... it'll have to stick out too high to the front of the cone. Basically, I think that someone's got a 2240H voice coil (for the 18") here, rather than a 2235H voice coil, in essence...

Thanks to anyone that can help...

Regards,
Gordon.