Can this CD be used in a 1" exit horn? I assume no, but assumptions are often wrong.
It is supposed to be a 0.8" driver.
In the long run I'd love to use it with a 8" driver underneath (synthesis 8 in a 2 way, or maybe 2250HPL in a 3 way) with a 1/2 scale M2 horn: http://www.audioheritage.org/vbullet...l=1#post379272
But first I will most probably make a 0.8"/1" adapter with a flare similar to 242x drivers.
The only bold-on 1" horns I have here are the 2344, so I might as well try that.
I received the units.
They are surprisingly tiny !
Exit is 21mm, bolting pattern 40mm, 4 screws.
Still have to determine the screw diameter, which is not an easy task when you only have metric screws at hand.
Inner diameter is around 3.6mm/0.14", if that rings a bell to anyone more used to imperial screws than I am
Let's hope they can do more than just noise
Thanks
Reminds me of the Weber side drafts on my old coupe. They look like they mean business.
Looks like a Rock & Roll machine
This driver is now used in the just released SCL-2 :
http://www.twice.com/thewire/harman-...ise-2017/64254
The SCL-2 is designed with a 2.5-way, triple 8-inch (200mm) driver configuration for low-frequency extension with high output capability and powerful dynamics. A D2415K dual voice coil, dual 1.5-inch (38mm) annular ring diaphragm Teonex® compression driver with advanced HDI geometry horn works in conjunction with powerful cast-frame, 8-inch (200mm) Advanced Aluminum Matrix cone woofers with low distortion motor structures.
The older SCL-3 and SCL-4 use the tiny 2409H driver already used in the 705i/708i
The SCL-2 seems to be exactly what I described here :
Perfect fit for a 8" woofer...
Here are some pictures of the new SCL-2, alongside the SCL-3 and SCL-4, courtesy of Skylinestar on the AVS forum :
A guy here were on ISE show were they were JBL running 3xSCL-2 in front and SCL-4 elsewhere and 4xS2S-EX. He was very impressed and had no doubt that JBL were "ISE best in show".
POS,
Have you done anymore with your 2415's yet?
Always fun learning more.......
nope
I was to busy/lazy to build the 0.8"/1" adapter.
I will put this on hold for now in the hope of seeing it appear in the install series with a detachable (and available!) HDI waveguide.
I doubt the baffle of that synthesis speaker can be obtained as part (or can it?)
There are currently 1 users browsing this thread. (0 members and 1 guests)