Hello
I have been lurking and thoroughly enjoying all the wonderful information on this fantastic board, and I am hoping someone can help me with biamping my 250ti.
I tried to search old posts for information on biamping the stock N250ti networks, but I could not find any schematics for what is needed to be done.
So my question is:
If I were to separate the LE14H-1 from the stock network and drive it with its own amp, and remove the LE14H-1 low pass components from the N250ti network, would any adjustments have to made to the rest of the N250ti network to compensate for the removed Le14H-1 low pass components?
I would of course be using a active crossover with proper slope and freq. to drive the low and high amps.
Thank you all for any help!