The wires (look like braided tinsel leeds) that come from the voice coil or drivers' center keep braking off of the tabs. The tabs, lugs, connectors or whatever their proper term is the ones that have the push on connectors coming from the x-over. I have resoldered them twice, don't play them loud at all, but still they break, not at the solder joint but just below. I assume by now I have over heated them after a few re-solderings and they have become brittle. Should I try to go into the innards and install new leeds or just replace the driver...and will a 115h-1 (From a L20t ?) work? thanks