Hey All

I have some TAD TN-4 crossovers, which are made to run either 2 x 1601's, or 1 x 1601 bass unit. It's a 2 way crossover which comes advertised as switchable between these two configurations.

Here's the weird bit -

I can see no switch, or obvious way of ''swapping'' the crossover between 2 x 1601 , and 1 x 1601.


Just using the TN-4 as is (with my 1 x 1601 p/side) I am getting a bass-light presentation, which leads me to assume I need to do " whatever TAD say I should " to swap their crossover between dual bass cone and single bass cone use.

So what's the problem?

..

agghhhh.. I just can't get ahold of ANYONE at Pioneer who knows the first thing about TAD products, most especially the 'TN' series of crossovers. I am peeing into the wind, and just getting wet trousers.

It's a huge frustration after spending so much on TAD drive units, and the crossovers (all bought used admittedly..but still!!! agggggh!)


Does ANYONE have a contact at TAD?
Anyone know anyone who knows someone at TAD?


Fingers crossed

Thx