One of the midrange drivers in my pair of 120ti speakers has died. Sucks 'cause it was the one of the two that had a perfect dome - lol. Anyway, I think the crossover may be damaged too, because when I swapped the 104h-1 drivers between left and right to test them, the good one only works in it's original cabinet. I'm not sure how to test the crossovers aside from hooking a speaker up to them. I don't even know how to test the drivers properly with a hand-held tester. The bad 104h-1 does make a little noise, but it's barely audible. Anyway, I guess my question is how do I test the crossover before I start looking to replace it? And how do I test drivers? I do have a multi-meter tester.
Also, if I decide to run a pair of 104h-2 drivers, as they are more readily available, would they sound good? I've had the 120 Ti speakers since new in 1990 and have ALWAYS LOVED them.