I intend to replace aluminium dustcaps on E120 with paper dustcaps.
What kind of glue did JBL use on these? Can the dustcap be removed after heating?
Any advice on the subject is appreciated
/Mårten
I intend to replace aluminium dustcaps on E120 with paper dustcaps.
What kind of glue did JBL use on these? Can the dustcap be removed after heating?
Any advice on the subject is appreciated
/Mårten
The glue used for the E120 dust cap could be either black Bostik or Loctite Black Max. It takes a bit of mental and manual creativity to remove either dustcap glue. I'm afraid you're on your own because the only determiner of success is your own manual talents and experience.
Good luck!!
Edgewound...JBL Pro Authorized...since 1988
Upland Loudspeaker Service, Upland, CA
Thanks Edgewound!
The Loctite seems to be cyanoacrylate with rubber. Acetone can be used to debond cyanoacrylate according to wikipedia. Ill try with an ugly driver first.
Another option would be to paint the dome with aquaplas or something similar.
I never did like the look of the chrome dome seen through the grill of a Twin Reverb!
Edit: Not trying to spam. What is the reason for changing?
The reason for changing is to see if it is possible to make them sound any better. I am using them as midranges. There is a rise above 1k that I believe is because of the aluminium dome.
Some kid of rise response in frequency response is expectable (over 1kHz,), concerning the directivity characteristics of 12"-inch drivers. Such behavior is visible on:
http://www.audioheritage.org/vbullet...l=1#post148781
and nicely explained in Altec Lancing Technical Letter no.237:
http://alteclansingunofficial.nlenet...ers/TL_237.pdf
expectable 6dB/octave rise in 'on-axis' response is well explained in above TNL-237,
but response decline with the angular off-axis response too, so some work on crossover network can be helpful.
I expect that total amount of radiated audio energy remains almost constant up to 2~4kHz.
"Painting" or exchanging dist cup I think would not give too much in 'flattening" the on-axis response,
so removing aluminum dust-cup can produce more trouble.
[QUOTE=maxwedge;329742]I never did like the look of the chrome dome seen through the grill of a Twin Reverb!
How's this?
OPUS POCUS
http://www.audioheritage.org/vbullet...=e140+dust+cap
Before You cut away the aluminium dome You can try to damp it by painting it with undercoating or something similar. What can You spoil?
Try to lend some measuring device, such as a Behringer DEQ2496 and a mike.
I would like to understand what causes the rise starting at 1 kHz.
Ruediger
There are currently 1 users browsing this thread. (0 members and 1 guests)