Results 1 to 5 of 5

Thread: 226J or 228H- has anyone used them?

  1. #1
    Junior Member
    Join Date
    Dec 2011
    Location
    Kings Mountain, NC
    Posts
    18

    226J or 228H- has anyone used them?

    Zilch (RIP) had mini-Econowaves with these drivers, but I can't find much about them other than in the Econowave threads. Was looking for something like a 2118 in the midrange, has the snap of the 2118, but could go a little deeper.

  2. #2
    Senior Member grumpy's Avatar
    Join Date
    Oct 2003
    Location
    SoCal
    Posts
    5,742
    Based on the AC28/95 box, a pair should be good to 60Hz (-3dB).
    I have a pair of the J-version and was conversing with Zilch about
    center channel use (sideways MTM) but when he passed, so did my
    zest for working on it. If I build it up, I'll post here. Seems like a
    good driver hiding in a stamped frame shell.

  3. #3
    Junior Member
    Join Date
    Dec 2011
    Location
    Kings Mountain, NC
    Posts
    18
    Yeah the motor is as state of the art as they come...lots of motor and lil lower Fs. Looks great on paper.

  4. #4
    Junior Member
    Join Date
    Dec 2011
    Location
    Kings Mountain, NC
    Posts
    18
    Grumpy, you wouldn't have any physical measurements of the drivers would you? Something like depth and diameter of the motor would be VERY helpful.

  5. #5
    Senior Member grumpy's Avatar
    Join Date
    Oct 2003
    Location
    SoCal
    Posts
    5,742
    4.25" deep overall, just over 4" from back of front flange to back of magnet.
    Largest part of magnet diameter is 6.25"

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •